Camry Solara SE L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-1316011.png)
2. Using a service-purpose wire harness tie down the side airbag assembly.
Wire harness: Stripped wire harness section 1.25 Sq.mm or more (0.0019 Sq.in or more)
HINT: To calculate the square of the stripped wire harness section
Square = 3.14 x Sq.(Diameter) divided by 4
CAUTION: If a wire harness which is too thin or some other thing is used to tie down the side airbag assembly, it may be snapped by the
shock when the airbag is deployed. This Is highly dangerous. Always use a wire harness for vehicle use which is at least 1.25 Sq.mm (0.0019
Sq.in).
3. Wind the wire harness around the stud bolts of the side airbag assembly as shown in the illustration.
4. Position the side airbag assembly inside the tire with the airbag deployment direction facing inside.
Tire size : Must exceed the following dimensions
Width 185 mm (7.28 in.)
Inner diameter 360 mm (14.17 in.)
CAUTION:
-
Make sure the wire harness is tight. It Is very dangerous when a loose wire harness results in the side airbag assembly coming free due to
the shock from the airbag deploying.
-
Always tie down the side airbag assembly with the airbag door facing inside.
NOTE: The tire will be marked by the airbag deployment, so when disposing of the airbag use a redundant tire.
