Camry Solara SE L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
Impact Sensor: Service and Repair
Front Airbag Sensor
Replacement Requirements
REPLACEMENT REQUIREMENTS
In the following cases, replace the front airbag sensor.
-
If the SRS has been deployed in a collision. (Replace both the left and right airbag sensors.)
-
If the front airbag sensor has been found to be faulty in troubleshooting.
-
If the front airbag sensor has been found to be faulty during checking items.
-
If the front airbag sensor has been dropped.
CAUTION: Be sure to follow the correct procedure for removal and installation of the front airbag sensor.
Airbag Sensor Connectors
DISCONNECTION
a. While holding both flank sides of the outer, slide the outer to the direction shown by an arrow.
b. Lock of the connectors is released, then disconnect the connectors.
HINT: Make sure to hold both flank sides of the outer. If holding the top and bottom sides, it will obstruct disconnection.
CONNECTION
a. Align the male connector (of the side of sensor) and female connector in the same direction as shown in the illustration and fit in them without
rubbing.
b. As they are fitted in, the outer slides rearward. Press it until the outer returns to its original position again.