Camry Solara SE L4-2164cc 2.2L DOHC (5S-FE) MFI (2000)
_mfi/Page-209003.png)
a. Remove the master switch with connector connected.
b. Attach a current-measuring probe to terminal 9 of the wire harness.
c. Turn the ignition switch ON and set the power window switch in the down position.
d. As the window goes down, check that the current flow is approximately 7 A.
e. Check that the current increases up to approximately 14.5 A or more when the window stops going down.
HINT: The circuit breaker opens some 4 - 40 seconds after the window stops going down, so that check must be done before the circuit breaker
operates.
If operation is as specified, replace the master switch.
INSPECT POWER WINDOW MASTER SWITCH CIRCUIT
Disconnect the connector from the master switch and inspect the connector on the wire harness side.
