Camry Solara SLEV6 V6-3.0L (1MZ-FE) (2000)
a. Check the stator for open circuit.
Using an ohmmeter, check that there is continuity between the coil leads.
If there is no continuity, replace the drive end frame assembly.
b. Check the stator for ground.
Using an ohmmeter, check that there is no continuity between the coil lead and drive end frame.
If there is continuity, replace the drive end frame assembly.
3. INSPECT BRUSHES
Using a vernier caliper, measure the exposed brush length.
Standard exposed length: 10.5 mm (0.413 in.)
Minimum exposed length: 1.5 mm (0.059 in.)
If the exposed length is less than minimum, replace the brushes and brush holder assembly.
4. INSPECT RECTIFIERS (RECTIFIER HOLDER)