Camry Solara SLEV6 V6-3.0L (1MZ-FE) (2000)
/Page-1091003.png)
1. SECURE PS GEAR ASSEMBLY IN VISE
Using SST, secure the gear assembly in a vise.
SST 09612-00012
2. REMOVE 2 TURN PRESSURE TUBES
a. Using SST, remove the 2 turn pressure tubes.
SST 09633-00020
b. Remove the 4 O-rings from the tubes.
3. REMOVE RH AND LH TIE ROD ENDS AND LOCK NUTS
a. Place matchmarks on the tie rod end, lock nut and rack end.
b. Loosen the lock nut, remove the tie rod end and lock nut.
c. Employ the same manner described above to the other side.
4. REMOVE RH AND LH CLIPS, RACK BOOTS AND CLAMPS
a. Using a screwdriver, loosen the 2 clamps.
b. Remove the 2 clips and boots.
HINT: Mark the RH and LH boots.
NOTICE: Be careful not to damage the boot.
5. REMOVE RH AND LH RACK ENDS AND CLAW WASHERS
