Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
If rear oil seal retainer is removed from cylinder block:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal edge. SST 09223-63010
(c) Apply MP grease to the oil seal lip.
If rear oil seal retainer is installed to cylinder block:
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer tap in the oil seal until its surface is flush with the rear oil seal retainer edge. SST 09223-63010