Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
Distributor: Testing and Inspection
California Vehicles
PROCEDURE
NOTE: "Cold" and "Hot" in the following sentences express the temperature of the coils themselves.
"Cold" is from -10°C (14°F) to 50°C (122°F).
"Hot" is from 50°C (122°F) to 100°C (212°F)
1. REMOVE THE DISTRIBUTOR CAP.
-
Remove the 2 bolts, and disconnect the distributor cap from the distributor housing.
2. REMOVE ROTOR.
3. REMOVE DUST PROOF COVER.
4. INSPECT AIR GAP.
-
Using Special Service Tool for the G1 and G2 sensors and a feeler gauge for the NE sensor, measure the air gap between the signal rotor and
sensor projection (SST 09240-00020 for G1 and G2 sensors).
Air gap: 0.2 - 0.5 mm (0.008 - 0.020 in)
-
If the air gap is not as specified, replace the distributor housing assembly.
5. DISCONNECT DISTRIBUTOR CONNECTOR.