Camry Wagon L4-132 2164cc 2.2L DOHC (5S-FE) (1995)
/Page-1451002.png)
b. Check to see that the inboard joint shaft slides smoothly in the thrust direction.
c. Check to see that there is no remarkable play in the radial direction of the inboard joint shaft.
d. Check for damage to boots.
2. Remove inboard and outboard joint boot clamps.
a. Using pliers, draw the hook together and remove the large inboard joint boot clamp and remove them.
b. Using a side cutter, cut the small inboard and 2 outboard joint boot clamps and remove them.
3. Remove inboard joint shaft.
a. Place matchmarks on the tripod and inboard joint shaft.
CAUTION: Do not punch the marks.
b. Remove the inboard joint shaft from the outboard joint shaft.
4. Remove tripod.
a. Using a snap ring expander, remove the snap ring.
b. Using a snap ring expander, temporarily slide the snap ring toward the outboard joint shaft side.
c. Place matchmarks on the outboard joint shaft and tripod.
d. Using a brass bar and hammer, remove the tripod from the outboard joint shaft.
e. Using a snap ring expander, remove the snap ring.
5. Remove inboard and outboard joint boots. Slide out the 2 boots.
CAUTION: Do not disassemble the outboard joint.
6. Remove dust cover:
LH Drive Shaft - Using Special Service Tool (SST) 09950-00020 and a press, remove the dust cover from the inboard joint shaft.
