Camry Wagon L4-2.0L (3S-FE) (1990)
CAUTION: Be careful not to damage the rubber lips on the pistons.
-
Insert the spring.
-
Align the grooves on the No.2 piston and master cylinder flange as shown, and insert the No.2 piston straight in, not at an angle.
CAUTION: If inserted at an angle, there is possibility of damaging the cylinder bore.
-
Using a screwdriver, align the grooves again.
NOTE: Tape the screwdriver tip before use.
CAUTION: Be careful not to scratch the cylinder bore.
-
Temporarily insert the straight pin, and check that it can be inserted easily.
-
Insert the spring and No. 1 piston straight in, not at an angle.
-
Push in the piston with a screwdriver and install the snap ring with snap ring pliers.
Install piston stopper bolt
-
Using a screwdriver, push the piston in all the way and insert the straight pin and then install the piston stopper bolt over the gasket. Torque the
bolt.
Torque: 10 Nm (7 ft lb)