Camry Wagon L4-2.0L (3S-FE) (1990)
/Page-1471003.png)
REMOVAL OF SAFETY PAD
1. DISCONNECT BATTERY CABLE FROM NEGATIVE TERMINAL
2. REMOVE STEERING WHEEL
3. REMOVE FRONT PILLAR GARNISH
Pry out the clips and pull the front pillar garnish upward to remove it by the hand.
4. REMOVE NO.1 UNDER COVER
5. REMOVE LOWER FINISH PANEL
(a) Remove the two screws and the engine hood release lever.
(b) (USA) Using a screwdrier, pry out the switch bases and the No.1 speaker panel.
HINT: Tape the screwdrier tip before use.
