Camry Wagon L4-2.0L (3S-FE) (1990)
/Page-811010.png)
-
Before assembling new discs, soak them in ATF for at least fifteen minutes.
3. CHECK DIRECT CLUTCH BUSHING
Using a dial indicator, measure the inside diameter of the direct clutch bushing.
Maximum inside diameter: 48.27 mm (1.9004 in.)
If the inside diameter is greater than the maximum, replace the direct clutch.
ASSEMBLY OF DIRECT CLUTCH
1. INSTALL CLUTCH PISTON IN DIRECT CLUTCH DRUM
a. Install new O-rings to the piston. Coat the O-rings with ATF.
b. Being careful not to damage the O-rings, press the piston into the drum with the cup side up.
2. INSTALL PISTON RETURN SPRING
a. Place the return spring and snap ring onto the piston.
