Camry Wagon L4-2.0L (3S-FE) (1990)
INSPECTION OF OVERDRIVE BRAKE
INSPECT DISCS, PLATES AND FLANGE
Check if the sliding surfaces of the discs, plates and flange are worn or burnt. If necessary, replace them.
HINT:
-
If the lining of the disc is exfoliated or discolored, or even a part of the printed numbers are defaced, replace all discs.
-
Before assembling new discs, soak them in ATF for at least fifteen minutes.
DISASSEMBLY OF OVERDRIVE DIRECT CLUTCH
1. CHECK PISTON STROKE OF DIRECT CLUTCH
Using a dial indicator, measure the piston stroke while applying and releasing the compressed air (4 - 8 kg/sq.cm, 57 - 114 psi or 392 - 785 kPa)
as shown.
Piston stroke: 1.75 - 2.49 mm
(0.0689 - 0.0980 in.)
SST 09350-32014 (09351-32190)
If the piston stroke is greater than the maximum, inspect each component.
2. REMOVE OVERDRIVE DIRECT CLUTCH FROM CASE