Camry Wagon L4-2.0L (3S-FE) (1990)
a. Coat new O-rings with ATF and install them to the piston.
b. Insert the spring and piston into the cylinder.
c. Plate the check ball on No.1 gasket.
d. Install the B0 accumulator assembly.
e. Install and torque the three bolts.
HINT: Each bolt length (mm (in.)) is indicated in the figure.
Torque: 67 kg-cm (58 in.-lb, 6.6 N.m)
13. INSTALL SOLENOIDS
a. Coat new O-rings with ATF and install them to the solenoids.
b. Install the lock-up solenoid.
c. Install and torque the bolt.
HINT: Bolt length (mm (in.)) is indicated in the figure.
Torque: 67 kg-cm (58 in.-lb., 6.6 N.m)