Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
Water Pump: Service and Repair
Water Pump Removal
1. Disconnect cable from negative terminal of battery
CAUTION: (w / Airbag): Work must be started after approx. 30 seconds or longer from the time the ignition switch is turned to the "LOCK"
position and the negative (-) terminal cable is disconnected from the battery.
2. Drain engine coolant
3. Disconnect radiator lower hose from water inlet pipe
4. Remove timing belt. See: Engine/Timing Components/Timing Belt/Service and Repair
5. Remove water inlet pipe
(a) Remove the bolt holding the water inlet pipe to the alternator belt adjusting bar.
(b) Remove the water inlet pipe and 0-ring.
6. Remove water inlet and thermostat