Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
/Page-329005.png)
-
If the pulley cannot be removed by hand, use two screwdrivers.
HINT: Position shop rags as shown to prevent damage.
21. REMOVE OIL PUMP
(a) Remove the nine bolts.
(b) Remove the oil pump by prying a screwdriver between the oil pump and main bearing cap.
(c) Remove the 0-ring.
OIL PUMP INSTALLATION
1. INSTALL OIL PUMP
(a) Remove any old packing (FIPG) material and be careful not to drop and oil on the contact surfaces of the oil pump and cylinder block.
^ Using a razor blade and gasket scraper, remove all the old packing (FIPG) material from the gasket surfaces and sealing grooves.
^ Thoroughly clean all components to remove all the loose material.
^ Using a non-residue solvent, clean both sealing surfaces.
(b) Apply seal packing to the oil pump as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent
^ Install a nozzle that has been cut to a 2-3 mm (0.08-0.12 in.) opening.
HINT: Avoid applying an excessive amount to the surface.
^ Parts must be assembled within 5 minutes of application. Otherwise the material must be removed and reapplied.
^ Immediately remove nozzle from the tube and reinstall cap.
(c) Place a new 0-ring in position on the cylinder block.
