Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
Ignition Cable: Testing and Inspection
V-Bank Cover
- Using a 5 mm hexagon wrench, remove the two nuts and V-bank cover.
Wire Removal
- Disconnect the high - tension cords at the rubber boot.
NOTICE:Pulling on or bending the cords may damage the conductor inside.
Wire Holder
- Using a screwdriver, lift up the lock claw and disconnect the holder from the distributor cap (ignition coil).
Wire Removal
- Disconnect the high-tension cord at the grommet. DO NOT pull on the cord.
NOTICE:
^ Pulling on or bending the cords may damage the conductor inside.