Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
/Page-958014.png)
3. INSTALL RH DRIVE SHAFT
-
Coat gear oil to the inboard joint and differential sliding surface
-
Install the drive shaft to the transaxle through the bearing bracket.
NOTICE: Do not damage the oil seal lip.
-
Using pliers, install a new snap ring.
-
Install a new bearing lock bolt and tighten it.
Torque: 32 N.m (330 kgf.cm, 24 ft.lbf)
4. CONNECT DRIVE SHAFT TO AXLE HUB Install the outboard joint side of the drive shaft to the axle hub.
NOTICE: Do not damage the boot.
5. CONNECT STEERING KNUCKLE TO LOWER ARM
Torque: 127 N.m (1,300 kgf.cm, 94 ft.lbf)
