Camry Wagon V6-180.5 2959cc 3.0L DOHC (3VZ-FE) (1993)
/Page-977006.png)
1. INSPECT NO.1 CLUTCH HUB INTO HUB SLEEVE
a. Install the clutch hub and shifting keys to the hub sleeve.
b. Install the shifting key springs under the shifting keys.
NOTE: Install the key springs positioned so that their end not in line.
2. INSTALL NEEDLE ROLLER BEARING, FIRST GEAR, SYNCHRONIZER RING AND NO.1 HUB SLEEVE TO OUTPUT SHAFT
a. Apply MP grease to the needle roller bearings.
b. Install the 1st gear.
c. Place the synchronizer ring (for 1st gear) on the gear and align the ring slots with the shifting keys.
d. Using SST and a press, install the 1st gear and No.1 hub sleeve.
SST 09316-60010 (09316-00040)
3. INSTALL SNAP RING
