Camry Wagon V6-2507cc 2.5L DOHC (2VZ-FE) (1988)
Fuel Pressure: Testing and Inspection
FUEL PRESSURE INSPECTION
a. Check the battery voltage above 12 volts.
b. Disconnect the cable from the negative (-) terminal of the battery.
c. Disconnect the cold start injector connector.
d. Put a suitable container or shop towel under the cold start injector pipe.
e. Remove the two union bolts, four gaskets, and cold start injector pipe.
NOTE: Slowly loosen the union bolt.
f.
Install SST (pressure gauge) to the delivery pipe with new two gaskets and union bolt.
*SST 09268-45012
Torque: 180 kg-cm (13 ft-lb, 18 N.m)
g. Wipe off any splattered gasoline.
h. Reconnect the battery negative (-) cable.
i.
Using a service wire, short terminals +B and FP of the check connector.
j.
Turn the ignition switch "ON".