Camry Wagon V6-3.0L (1MZ-FE) (1994)
/Page-1418004.png)
NOTE: The snap ring should be installed so that its beveled side faces up.
c. Using a SST 07110-61050 and torque wrench, fasten the magnetic clutch lead wire to the cylinder block.
Torque: 3.4 Nm (30 in.lb)
2. Install rotor.
a. Install the rotor on the compressor shaft.
b. Using a SST 07114-84020, install the new snap ring.
CAUTION: Do not spread the point of SST widely. Max width: 23.1 mm
NOTE: The snap ring should be installed so that its beveled side faces up.
