Camry Wagon V6-3.0L (1MZ-FE) (1994)
Throttle Body: Testing and Inspection
Off-Vehicle Inspection
INSPECTION
1. Clean throttle body.
^
Using a soft brush and carburetor cleaner, clean the cast parts.
^
Using compressed air, clean all the passages and apertures.
NOTE: To prevent deterioration, do not clean the Throttle Position Sensor.
2. Inspect throttle valve.
^
Apply vacuum to the Throttle Opener.
^
Check that there is no clearance between the throttle stop screw and throttle lever when the throttle valve is fully closed.
3. Inspect Throttle Position Sensor.
^
Apply vacuum to the Throttle Opener.
^
Insert a thickness gauge between the throttle stop screw and stop lever.
^
Using an ohmmeter measure the resistance between each terminal.
Clearance between
Between
Resistance