Camry Wagon V6-3.0L (1MZ-FE) (1994)
/Page-1393001.png)
Wheel Bearing: Service and Repair
Fig. 7 Rear Axle Hub Replacement
1.
On models equipped with drum brakes, remove brake drum, Fig. 7.
2.
On models equipped with disc brakes, remove brake caliper and position aside using suitable wire, then remove brake rotor.
3.
Using suitable dial indicator, measure bearing play in axial direction, maximum of .0020 inch should be indicated, if not as indicated, replace
bearing.
4.
Using suitable dial indicator, measure deviation at surface of axle hub outside hub bolt, maximum of .0028 inch should be indicated, if not as
indicated, replace axle shaft and bearing.
5.
Remove four rear axle hub attaching bolts, then remove axle hub and O-ring.
6.
On models equipped with anti-lock brakes, do not disassemble rear axle shaft and bearing.
7.
On models less anti-lock brakes, using suitable hammer and chisel, unstake and remove locknut.
8.
Using suitable tool, remove axle shaft from axle hub.
9.
Remove bearing inner race (outside).
10.
Reverse procedure to install.
