Camry XLE Sedan L4-2.4L (2AZ-FE) (2002)
Camshaft Bearing: Specifications
INSTALL CAMSHAFT
a. Tighten camshaft bearing cap No. 1 and No. 3 as the sequence shown in the illustration.
Torque:
Bearing cap No. 1 30 Nm (301 kgf-cm, 22 ft. lbs.)
Bearing cap No. 3 9 Nm (92 kgf-cm, 80 inch lbs.)
NOTICE:
-
Tighten the bolts after deciding the position for the thrust direction of the camshaft by bearing cap No. 1.
-
Install the camshaft with its timing mark of camshaft timing gear on top.
INSTALL NO. 2 CAMSHAFT
a. Tighten camshaft bearing cap No. 2 and No. 3 as the sequence shown in the illustration.
Torque:
Bearing cap No. 2 30 Nm (301 kgf-cm, 22 ft. lbs.)
Bearing cap No. 3 9 Nm (92 kgf-cm, 80 inch lbs.)
NOTICE:
-
Tighten the bolts after deciding the position for the thrust direction of the camshaft by bearing cap No. 2.
-
Camshaft with its timing mark of camshaft timing gear on top.