toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Spark Plug > < Timing Marks and Indicators|Locations
Page 1
background image

Ignition Cable: Testing and Inspection

INSPECT HIGH-TENSION CORDS

a. Remove the high-tension cords.

Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.

NOTE:  Pulling on or bending the cords may damage the conductor inside.

b. Using an ohmmeter, measure the high-tension cord resistance.

Maximum resistance: 25 K Ohms per cord
If the resistance is greater than maximum, check the terminals.
If necessary, replace the high-tension cord.

c. Reinstall the high-tension cords.

Spark Plug > < Timing Marks and Indicators|Locations