Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
Ignition Cable: Testing and Inspection
INSPECT HIGH-TENSION CORDS
a. Remove the high-tension cords.
Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.
NOTE: Pulling on or bending the cords may damage the conductor inside.
b. Using an ohmmeter, measure the high-tension cord resistance.
Maximum resistance: 25 K Ohms per cord
If the resistance is greater than maximum, check the terminals.
If necessary, replace the high-tension cord.
c. Reinstall the high-tension cords.