Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
b. Without holding the seat track handle, mount the seat to the vehicle.
HINT: If holding the seat track handle, the adjusted most front position will slip off.
c. Connect the side airbag connector.
d. Tighten the bolts on the rear side temporarily, starting from the bolt on the inner side tighten them completely.
Torque: 37 Nm (375 kgf.cm, 27 ft.lbf)
e. Slide the seat to the rearmost position to install the bolts on the front side.
Torque: 37 Nm (375 kgf.cm, 27 ft.lbf)
Power Seat
Removal w/Power Seat
NOTE:
-
If the wiring connector of the SRS is disconnected and the ignition switch is at ON or ACC position, DTCs will be recorded.
-
Never use the airbag parts from another vehicle. When replacing parts, replace them with new parts.