Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
18. INSTALL RIGHT-HAND AND LEFT-HAND RACK BOOTS, CLAMPS AND CLIPS
a. Ensure that the steering rack hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.
b. Install the boot.
NOTICE: Be careful not to damage or twist the boot.
c. Using SST, tighten the clamp as shown in the illustration.
SST 09521-24010
19. INSTALL RIGHT-HAND AND LEFT-HAND TIE ROD ENDS AND LOCK NUTS
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, torque the nut.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)