toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Keyless Entry - Remote Transmitter Programming Guide|Page 7511 > < Keyless Entry - Remote Transmitter Programming Guide|Page 7509
Page 1
background image

Keyless Entry Transmitter: Technical Service Bulletins
Keyless Entry - Programming Remote Transmitters

ELECTRICAL
EL008-98

December 4, 1998

Title:
PROGRAMMING OEM WIRELESS DOOR LOCK REMOTE TRANSMITTER

Models:
'97 - '98 Camry

Introduction
This bulletin describes procedures used to program the three button remote transmitter to vehicles that are equipped with Wireless Door Lock Control.
The following information applies only to the Factory Wireless Door Lock Control, not dealer or port installed options that also utilize remotes, such as
VIP Keyless Entry/RS3000 or any aftermarket system.

Verification of Factory Wireless Door Lock Control can easily be performed by identifying the TDS status monitor, functioning remote, or model grade.

^

The Remote Transmitter has LOCK, UNLOCK, and PANIC features.

^

The TDS Status Monitor is located in the Tachometer.

NOTE:

When a new remote is programmed, all previous codes are erased. Because of this, all remotes should be entered during the same programming
session, otherwise a remote may no longer be registered and operate the vehicle.

For customer Satisfaction, request that any existing remote be furnished when programming a new or replacement unit.

Affected Vehicles
^

1997-1999 Camrys:

1997 - 1998 All XLE (standard equipment) and some LE (optional)
1999 All XLE only

Warranty Information

Keyless Entry - Remote Transmitter Programming Guide|Page 7511 > < Keyless Entry - Remote Transmitter Programming Guide|Page 7509