Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Brake Master Cylinder: Service and Repair
REMOVAL
1. Disconnect Level Warning Switch connector.
2. Take out fluid with syringe.
CAUTION: Do not let brake fluid remain on a painted surface. Wash it off immediately.
Disconnecting Master Cylinder Brake Lines
3. Disconnect brake lines.
-
Using Special Service Tool (SST 09023-00100), disconnect the 5 brake lines.
4. Remove Master Cylinder.
-
Remove the 2 nuts, and pull out the Master Cylinder and gasket.
DISASSEMBLY
1. Remove reservoir.
-
Remove the set screw and pull out the reservoir.
-
Remove the cap and strainer from the reservoir.
2. Remove 2 grommets.
3. Place cylinder in vise.
4. Remove piston stopper bolt.
NOTE: Using a screwdriver, push the pistons in all the way and remove the piston stopper bolt and gasket. Tape the screwdriver tip before use.
5. Remove 2 pistons and springs.
