Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
1. A/T: Install oil cooler to lower tank.
(a)
Install 2 new O-rings to the oil cooler.
(b) Install the 2 plate washers and nuts.
Torque: 8.3 Nm (74 inch lbs.)
(c)
Install the cooler pipe with the nut and bolt.
Torque: 14.7 Nm (11 ft. lbs.) for nut.
2. Inspect lock plate.
Inspect the lock plate for damage.
NOTE:
^
If the sides of the lock plate groove are deformed, reassembly of the tank will be impossible.
^
Therefore, first correct any deformation with pliers or similar object. Water leakage will result if the bottom of the lock plate groove is
damaged or dented.
CAUTION: The radiator can only be recaulked 2 times. After the 2nd time, the radiator core must be replaced.
3. Install new O-rings and tanks.
(a)
After checking that there are no foreign objects in the lock plate groove, install the new O-ring without twisting it.
NOTE: When cleaning the lock plate groove, lightly rub it with sand paper without scratching it.
(b) Install the tank without damaging the O-ring.
(c)
Tap the lock plate with a soft-faced hammer so that there is no gap between it and the tank.
