Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
6. Install timing belt guide facing the cup side outward.
7. Install no.1 timing belt cover
a. Check that the timing belt cover gasket has no cracks or is peeling, etc.
^
If the gasket has cracks or peeling, etc., replace it using these steps:
^
Using a screwdriver and gasket scraper, remove all the old gasket material.
^
Thoroughly clean ail components to remove all the loose material.
^
Remove the backing paper from a new gasket and install the gasket evenly to the part of the timing belt cover shaded black in the
illustration.
^
After installing the gasket, press down on it so that the adhesive firmly sticks to the timing belt cover.
b. Install the timing belt cover with the 4 bolts.
c. Install the clamp of the crankshaft position sensor wire to the timing belt cover.
d. Install the crankshaft position sensor wire to the clamp on the timing belt cover.
8. Install crankshaft pulley
a. Align the pulley set key with the key groove of the pulley, and slide on the pulley.
b. Using SST, install the pulley bolt.
SST 09213-54015 (91651-0855 for type A), 09330-00021
