Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
High-Tension Cord: Testing and Inspection
High-Tension Cords
1. Remove high-tension cords.
Disconnect the high-tension cords at the rubber boot.
Do not pull on the high-tension cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
2. Inspect high-tension cord resistance.
Using an ohmmeter, measure the resistance.
Maximum resistance: 25 K ohms per cord
If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord.
3. Reinstall high-tension cords.
