toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

With Automatic Transmission|Page 4045 > < With Automatic Transmission|Page 4043
Page 1
background image

Charcoal Canister: Testing and Inspection
With Manual Transmission

Charcoal Canister - Manual Transmission Only 

1. Remove charcoal canister.
2. Remove cap from charcoal canister.

3. Visually inspect charcoal canister.

Look for cracks or damage.

4. Check for clogged filter and stuck check valve.

(a) Blow low pressure compressed air (4.71 kPa (48 gf/sq.cm, 0.68 psi)) into port A and check that air flows without resistance from the other

ports.

(b) Blow low pressure compressed air into port B and check that air does not flow from the other ports.

If a problem is found, replace the charcoal canister.

5. Clean filter in canister.

Clean the filter by blowing 294 kPa (3 kgf/sq.cm, 43 psi) of compressed air into port A while holding port B closed.

NOTICE:
-

Do not attempt to wash the canister.

With Automatic Transmission|Page 4045 > < With Automatic Transmission|Page 4043