Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Removal
INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with the 4 screws.
Torx wrench: T40 (Part No. 09042-00020 or locally manufactured tool)
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
b. Connect the connector.
NOTICE:
^
Installation of the connector is done with the sensor assembly installed.
^
Make sure that the sensor assembly is installed to the specified torque.
^
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
^
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
^
After installation, shake the sensor assembly to check that there is no looseness.