Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
NOTE:
Before installation of the fluorocarbon resin tape, it is necessary to pre-release the colored film about 5 mm for each side. (Not fully released.)
B.
By pulling up the seat belt, put the fluorocarbon resin tape through the hole of the shoulder belt anchor. Match the shoulder belt anchor to
the center of the tape.
C.
Remove the upper side colored film from the fluorocarbon resin tape, and securely affix the tape to the outside of the shoulder belt anchor.
D.
Remove the lower side colored film from the fluorocarbon resin tape, and securely affix the tape to the outside of the shoulder belt anchor.
NOTE:
^
Be sure to affix the fluorocarbon tape securely along all edges.
^
Pay attention not to make any wrinkles or slack in the fluorocarbon resin tape.
E.
Remove the clip.
