Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
13.7 - 19.6 N (1.4 - 2.0 kgf, 3.0 - 4.4 lbf)
1.4 kW type:
17.6 - 23.5 N (1.8 - 2.4 kgf, 3.9 - 5.3 lbf)
Minimum spring installed load:
1.2 kW type:
9.8 N (1.0 kgf, 2.2 lbf)
1.4 kW type:
11.8 N (1.2 kgf, 2.6 lbf)
If the installed load is less than minimum, replace the brush springs.
Brush Holder
INSPECT BRUSH HOLDER INSULATION
Using an ohmmeter, check that there is no continuity between the positive (+) and negative (-) brush holders. If there is continuity, repair or
replace the brush holder.
Clutch and Gears
1. INSPECT GEAR TEETH
Check the gear teeth on the pinion gear, idler gear and clutch assembly for wear or damage.
If damaged, replace the gear or clutch assembly. If damaged, also check the drive plate ring gear for wear or damage.
2. INSPECT CLUTCH PINION GEAR
Hold the starter clutch and rotate the pinion gear counter-clockwise, and check that it turns freely. Try to rotate the pinion gear clockwise and
check that it locks. If necessary, replace the clutch assembly.
a. Mount a brass bar in a vise, and install the starter housing and clutch assembly to the brass bar.
b. Push down the pinion gear.