Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
5. Check fluid pressure reading with valve opened.
a. With the engine idling, open the valve fully.
b. Measure the fluid pressure at engine speeds of 1,000 rpm and 3,000 rpm.
Fluid Pressure Difference: 490 kPa (71 psi) or less.
CAUTION: Do not turn the steering wheel.
6. Check fluid pressure reading with steering wheel turned to full lock. With the engine idling and valve fully opened, turn the wheel to full lock.
Minimum Fluid Pressure: 7,845 kPa (1,138 psi).
NOTE:
^
Do not maintain lock position for more than 10 seconds.
^
Do not let the fluid temperature become too high.
7. Disconnect the SST 09631-22020, then connect the pressure feed tube, torque to 20 Nm (15 ft. lbs.).
NOTE:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.
8. Bleed power steering system. Refer to Power Steering Bleeding.
