Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
1. Install pressure feed tube.
a. Torque the union bolt with a new gasket to 52 Nm (38 ft. lbs.).
NOTE: Make sure the stopper of the tube is touching the front bracket, as shown, then torque the union bolt.
b. Install the oil pressure switch to the union bolt, torque to 21 Nm (15 ft. lbs.).
2. Install PS vane pump assembly with pressure feed tube. Temporarily tighten the 2 (A and B) bolts.
3. Install drive belt.
a. Adjust drive belt tension.
b. Using Special Service Tool (SST) 09249 - 63010, torque the A bolt to 29 Nm (21 ft. lbs.).
