Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Reused nut: 196 Nm (145 ft. lbs.).
New nut: 255 Nm (188 ft. lbs.).
Nut B: 181 Nm (134 ft. lbs.)].
Installation Note:
-
After stabilizing the suspension, torque the nuts.
-
If reusing-the 2 nuts, coat the nut's threads with engine oil.
b. Remove the bolt and nut, and disconnect the strut rod from the rear axle carrier.
[Torque: 113 Nm (83 ft. lbs.)].
CAUTION: When removing/installing bolt, stop the nut from rotating and loosen/torque the bolt.
c. Remove the 2 nuts and bolts on the lower side of the shock absorber.
d. Remove the nut, bolt and No.2 lower suspension arm.
e. Remove the rear axle carrier.
8. Install in reverse order of removal, noting the torque specifications in brackets [ ].
9. After installation, check the ABS speed sensor signal (ABS equipped) and rear wheel alignment.
