Camry XLE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
Throttle Valve Cable/Linkage: Service and Repair
ON-VEHICLE REPAIR
1. Disconnect throttle cable.
a. Disconnect the cable from the throttle linkage.
b. Disconnect the cable from the cable clamps in the engine compartment.
2. Remove park/neutral position switch. See Powertrain Management.
3. Remove valve body.
4. Remove throttle cable.
a. Remove the retaining bolt and plate.
b. Pull out the cable from the transaxle case.
INSTALLATION
-
Installation is in the reverse order of the previous steps.
INSTALLATION HINT:
-
If throttle cable is new, stake the stopper on the inner cable:
a. Bend the cable so there is a radius of about 200 mm (7.87 in.)
b. Pull the inner cable lightly until slight resistance is felt, and hold it there.
c. Stake the stopper, 0.8-1.5 mm (0.031-0.059 in.) from the end of outer cable.
-
After installation, fill ATF and check the fluid level. See Automatic Transaxle Fluid.
-
Adjust the throttle cable. See Adjustments
