Celica L4-1.8L (1ZZ-FE) (2004)
Seat Belt Tensioner: Removal and Replacement
REMOVAL
NOTE:
-
If the wiring connector of the seat belt pretensioner is disconnected with the ignition switch at ON diagnostic trouble codes will be recorded.
-
Never use seat belt pretensioner from another vehicle. When replacing parts, replace them with new parts.
1. REMOVE DOOR SCUFF PLATE
Using a screwdriver, remove the door scuff plate.
HINT: Tape the screwdriver tip before use.
2. REMOVE PACKAGE TRAY TRIM
3. REMOVE REAR SEAT
4. REMOVE LUGGAGE COMPARTMENT TRAY
a. Using a clip remover, remove the 2 clips.
b. Using a screwdriver, remove the luggage compartment tray.
HINT: Tape the screwdriver tip before use.
5. REMOVE LUGGAGE COMPARTMENT MAT
6. REMOVE REAR DECK TRIM COVER
a. Remove the 2 bolts and 2 hooks.
b. Remove the 3 clips.
c. Using a screwdriver, remove the rear deck trim cover.
HINT: Tape the screwdriver tip before use.
7. REMOVE DECK TRIM SIDE PANEL