toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Procedures|Page 4458 > < Procedures|Page 4456
Page 2
background image

a. Remove the screw and No. 1 luggage compartment trim hook.
b. RH side:

Using a screwdriver, remove the rear room light, then disconnect the connector.

HINT:  Tape the screwdriver tip before use.

c. Remove the 2 clips.
d. Using a screwdriver, remove the deck trim side panel.

HINT:  Tape the screwdriver tip before use.

8. REMOVE REAR SEATBACK HINGE
9. REMOVE REAR SEATBACK LOCK STRIKER

10. REMOVE REAR SEAT OUTER BELT FLOOR ANCHORS
11. REMOVE QUARTER TRIM PANEL

Using a screwdriver, remove the quarter trim panel.

HINT:  Tape the screwdriver tip before use.

12. REMOVE FRONT SEAT OUTER BELT SHOULDER ANCHOR
13. REMOVE FRONT SEAT OUTER BELT FLOOR ANCHOR
14. REMOVE RETRACTOR OF FRONT SEAT OUTER BELT

CAUTION:  Never disassemble the front seat outer belt.

NOTE:  When removing the retractor of front seat outer belt, take care not to pull the seat belt pretensioner wire harness.

a. Disconnect the pretensioner connector as shown in the illustration.

Procedures|Page 4458 > < Procedures|Page 4456