Celica L4-1.8L (1ZZ-FE) (2004)
1. INSTALL FRONT AIRBAG SENSOR LH AND RH
a. Install the front airbag sensors with the 4 bolts.
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
b. Connect the front airbag sensor connector.
NOTE:
-
Connection of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor is installed with the specified torque.
-
If the sensor has been dropped, or there are cracks, dents or other detects in the case, brackets or connector, replace the removed sensor
with a new one.
-
The front sensor is equipped with an electrical connection check mechanism. Be sure to lock this mechanism securely when connecting the
connector. If the connector is not securely locked, a malfunction code will be detected by the diagnostic system.
HINT: Install the front airbag sensor with the arrow on the sensor facing toward the front of the vehicle.
2. INSTALL HEADLIGHT
Install headlights with the 4 bolts and 2 screws.
3. INSTALL AIR CLEANER CASE
Install the air cleaner case with the 2 bolts.
4. INSTALL AIR FILTER
5. INSTALL AIR CLEANER CAP
6. INSTALL AIR CLEANER HOSE