Celica L4-1.8L (1ZZ-FE) (2004)
-
Do not coat Primer M to the adhesive.
-
Do not keep any of the opened Primer M for later use.
6. COAT CONTACT SURFACE OF GLASS WITH PRIMER "G"
a. Using a brush or sponge, coat the edge of the glass and the contact surface with Primer G as shown in the illustration.
b. When the primer is coated wrongly to the area other than the specified, wipe it off with a clean shop rag before the primer dries.
NOTE:
-
Allow 3 minutes or more to dry the primer coated surface.
-
Do not keep any of the opened Primer G for later use.
7. APPLY ADHESIVE
a. Cut off the tip of the cartridge nozzle.
Part No. 08850-00801 or equivalent
HINT: After cutting off the tip, use all adhesive within the time described in the table.
b. Load the cartridge into the sealer gun.