Celica L4-1.8L (2ZZ-GE) (2005)
/Page-23010.png)
3. CONTINUITY CHECK (OPEN CIRCUIT CHECK)
a. Disconnect the connectors at both ECU and sensor sides.
b. Measure the resistance between the applicable terminals of the connectors.
Resistance: 1 ohm or less
HINT: Measure the resistance while lightly shaking the wire harness vertically and horizontally.
4. RESISTANCE CHECK (SHORT CIRCUIT CHECK)
a. Disconnect the connectors on both ends.
b. Measure the resistance between the applicable terminals of the connectors and body ground. Be sure to carry out this check on the connectors
on both ends.
Resistance: 1 Mohm or higher
HINT: Measure the resistance while lightly shaking the wire harness vertically and horizontally.
