Celica L4-1.8L (2ZZ-GE) (2005)
h. Disconnect the PS gear assembly from the suspension member.
(1) Remove the 4 set bolts.
Torque: 58 Nm (591 kgf-cm, 43 ft. lbs.)
(2) Tie the PS gear assembly to suspend it securely.
i.
Remove the bolt A and 3 nuts, and disconnect the engine rear mount.
Torque: 52 Nm (530 kgf-cm, 38 ft. lbs.)
j.
Remove the 2 bolts (B) and disconnect the engine front mount.
Torque: 52 Nm (530 kgf-cm, 38 ft. lbs.)
k. Using a transmission jack, support the suspension member.
l.
Remove the 6 bolts (C and D) and lower the suspension member.
Torque:
Bolt C: 157 Nm (1,600 kgf-cm, 116 ft. lbs.)
Bolt D: 39 Nm (400 kgf-cm, 29 ft. lbs.)
m. Remove the 2 bolts, nut and lower suspension arm.
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the front wheel alignment.