Celica L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
/Page-414001.png)
Water Pump: Service and Repair
Removal and Installation
1. Install thermostat and water inlet to water pump cover.
a. Install a new gasket to the thermostat,
b. Align the jiggle valve of the thermostat with the upper side of the stud bolt, and insert the thermostat in the water pump.
NOTE:The jiggle valve may be set within 50 of either side of the prescribed position.
c. Install the water inlet with the two nuts.
Torque: 9.3 Nm (82 in lb)
2. Assemble water pump and water pump cover. Install a new gasket and the water pump to the pump cover with the three bolts.
Torque: 8.8 Nm (78 in lb)
3. Install water pump and water pump cover assembly.
a. Install new 0-ring and gasket to the water pump cover.
