Celica L4-96.8 1587cc 1.6L DOHC (4A-FE) (1990)
Apply lithium soap base glycol grease to rubber parts indicated by arrows
Install two springs and pistons
CAUTION: Be careful not to damage the rubber lips on the pistons.
Insert the two springs and pistons straight in, not at an angle.
CAUTION: If insert at an angle, there is possibility of damaging the cylinder bore.
Push in the piston with a screwdriver and install the snap ring with snap ring pliers.
NOTE: Tape the screwdriver tip before use.
Using a screwdriver, push the piston in all the way and install the piston stopper bolt over the gasket. Torque the bolt.
Torque: 10 Nm (7 ft lb)
Install two grommets
Install the cap and strainer to the reservoir.
Push the reservoir onto the cylinder.