Celica L4-96.8 1587cc 1.6L DOHC (4A-FE) (1990)
/Page-853001.png)
Valve Body: Service and Repair
Removal
1.
Clean area around pan, then drain transmission fluid, then remove engine undercover.
2.
Remove oil pan and gasket, then the oil strainer.
3.
On A131L, A241E, A241L, A243L and A244E models, remove apply tube bracket attaching bolts, then the apply tube.
4.
On all models, remove oil tubes using a suitable screwdriver, then the manual detent spring.
5.
On A131L models, remove manual valve, then the manual valve body.
6.
On A240L, A241E, A241H, A241L, A243L and A244E models, disconnect solenoid connector.
7.
On all models, remove valve body attaching bolts, then disconnect throttle cable.
8.
On A240L, A241E, A241H, A241L and A243L models, disconnect manual valve connecting rod.
9.
On all models, remove valve body, then the governor apply gasket.
10.
On A131L models, remove governor oil strainer.
Installation
1.
On A131L models, install governor oil strainer.
2.
On all models, install governor apply gasket.
3.
On A240E, A241E, A240L, A241H, A241L, A243L and A244E models, connect manual valve connecting rod.
4.
On all models, hold valve body in place, then manually retain cam in downward position and slip cable end into slot.
Fig. 5 Valve Body Bolt Identification.
Fig. 6 Valve Body Bolt Identification.
Fig. 7 Valve Body Bolt Identification.
