Celica 2WD L4-2.0L (3S-FE) (1988)
/Page-772002.png)
Fig. 12 Disc brake assembly. 1988 Celica W/all wheel drive
4.
Refer to Figs. 11 and 12, and remove the following components:
a. Brake pads.
b. Anti-squeal shims.
c. Pad wear indicator plates.
d. Support plates.
e. Anti-squeal springs.
5.
Install new pad support plates.
6.
Install new pad wear indicator plates on each pad with arrow pointing in direction of disc rotation.
7.
Install new anti-squeal shims on each pad.
8.
Install each brake pad on to each support plate.
9.
Install anti-squeal springs.
10.
Siphon out a small amount of brake fluid from reservoir and press caliper piston in with hammer handle. Change one brake pad at a time to
prevent chance of opposite piston from flying out.
11.
Install caliper taking care not to wedge dust boot. Torque attaching bolts to 18 ft. lbs. on all except 1987-88 Camry and Celica GTS. On 1987-88
Camry, torque attaching bolts to 29 ft. lbs. On Celica GTS models, torque attaching bolts to 27 ft. lbs.
12.
Install wheel and check that brake fluid level is at MAX line.
Caliper, Replace
1.
Raise and support vehicle and remove front wheel.
2.
Remove union bolt and disconnect brake hose. Use suitable container to catch brake fluid.
3.
Remove bolts and remove caliper, Fig. 12.
4.
Remove anti-squeal shims and brake pad wear indicator plates.
5.
Remove support plates.
6.
Reverse procedure to install.
Disc, Replace
1.
Remove caliper as described under "Caliper, Replace".
2.
Scribe alignment marks between brake disc and hub, then remove disc.
3.
Reverse procedure to install.
